Zennio Z41 Instrukcja Obsługi Pobierz pdf (Strona 6)

ZENNiO AVANCE Y TECNOLOGÍA _vwww.zennio.com

After connecting the external power supply, the panel will flash briefly. After 7 seconds, a loading

image appears, with the Zennio logo and “Loading…” 23 seconds later, more or less, a beep will be

heard, and the status page will appear (Figure 1.3).

Figure 1.3: Status page

The box “KNX” shows the physical address assigned to the panel or “x.x.x” if the KNX bus is not

connected or the Z41 application has yet to be downloaded. The box “Software” indicates whether

the application program is compatible with the Z41 firmware “OK” or not “Error”. The box “Sync”

shows the synchronization status of the panel. When it reaches 100%, the Home page of the Z41

will be displayed and the Z41 is ready for use. The box “Ethernet” shows the IP address assigned

to the Z41 if the Ethernet cable is connected.

The status page will be also shown every time the KNX bus power fails, or the device is reset via

ETS or directly from the tools page.

Once the panel is connected to the KNX bus, both the physical address and the associated

application program can be downloaded using ETS4.

A short press of the programming button (2) allows the Z41 to be put in programming mode, at

which point the programming LED (3) will glow red. If this button is held while plugging the device

into the KNX bus, the Z41 will enter secure mode and the LED will flash red.

To obtain more detailed information about the technical features of the Z41, as well as security and

installation information, please refer to the touch panel Datasheet, included in the original

packaging of the device and also available at: http://www.zennio.com.

1 2 3 4 5 6 7 8 9 10 11 ... 52 53

Brak uwag

Zennio Z41 Instrukcja Obsługi Strona 6